Marking Sequence
Home Up

 

Search News CMT Library Air Impact Markers Stamps Dot-Peen-Scribe Marking Machines Hand Tools Hot Stamp Numbering Heads Utilities

Basic Roll Marking

For roll marking the mark is “rolled” onto the part. It is an economic solution in applications where tonnage requirements make a press too costly. Also, a practical method where fragile parts would be damaged by heavy stamping pressure. This method can be used on both flat and round parts.

Roll Marking Sequence

Step #1—Part in position to be marked. May require part locating fixture or roll carriage as shown
Step #2—Marking die approaches and contacts part. Columbia Marking Tools’ “ Seek & Find” pressure system assures constant marking pressure on the part at all times.
Step #3—Marking die moves across part. Approximately one character is in contact with the surface of the part at any time. Round part rolls with die in roll carriage.

 
Step #4—After moving the length of the slide stroke the roll marking die retracts from the part.
 

Simple Selection Process

1. Machine

2. Tooling

3. Dies

|  Home |  Top  | Request Catalog  |  Request Quotation  | Send E-Mail| MAP|

Columbia Marking Tools Inc: 27430 Luckino Dr, Chesterfield MI 48047

telephone:586-949-8400 fax:586-949-8401